>>>>>型號:IS220PAICH2A 模擬I/O包 I/O端口

【功能描述】

該IS220PAICH2A型號被描述為模擬I/O包，已獲準用于危險和非危險場所。在模型的正面，有四個指標。底部還有一個端口，被描述為I/O端口。PAIC電池組可以使用多種電壓，PAIC電池組的最小電壓為27點4伏直流電。

由于IS220PAICH2A套件能夠在許多地點使用，因此獲得了各種認證，其中一些是危險場所、一區二組IIC、一類二區A、B、C、D組和ATEX二區、IIC組和非危險場所。以下認證用于地點，UL E207685和UL DEMKO 12 ATEX 1114875X，請注意UL E207685認證在許多地點使用。

IS220PAICH2A單元可以使用三種型號，即IS200STAIH1A和IS200STAIH2A以及IS20TBAIH1C型號。所有這些型號都被稱為輸入輸出端子板。

PAIC I/O包的典型位置將位于兩個可用VME機架之一中，即13或21個插槽機架。請注意，該裝置通常與三重模塊化冗余架構系統一起使用。TMR系統有一個單獨的控制模塊、I/O網絡和主處理器卡。

 >>>>>型號:IS220PAICH2A 模擬I/O包 I/O端口

【英文介紹】

The IS220PAICH1A model is described as an analog I/O package that has been approved for use in hazardous and non-hazardous locations. On the front side of the model, there are four indicators. There is also a port on the bottom, which is described as an I/O port. The PAIC battery pack can use a variety of voltages, the minimum voltage of the PAIC battery pack is 27.4 volts DC.

Because the IS220PAICH1A kit is capable of being used in many locations, various certifications have been obtained, some of which are Hazardous Sites, Zone 1 Group 2 Iics, Zone 1 Group 2 A, B, C, D and ATEX Zone 2, IIC Group and non-hazardous Sites. The following certifications are used in locations, UL E207685 and UL DEMKO 12 ATEX 1114875X, please note that UL E207685 certifications are used in many locations.

The IS220PAICH1A unit can be used in three models, namely the IS200STAIH1A and IS200STAIH2A, and the IS20TBAIH1C model. All of these models are referred to as input/output terminals.

The typical location for a PAIC I/O package will be in one of the two available VME racks, i.e. 13 or 21 slot racks. Note that this device is often used with triple modular redundant architecture systems. The TMR system has a separate control module, I/O network, and main processor card.

>>>>>型號:IS220PAICH2A 模擬I/O包 I/O端口